Bio-Protect 2

PROBLEM AND SOLUTION

Problems can be prevented or fought with the addition of Bio-Protect 2.
With correct use fungus will be detroyed and growth reduced and prevented.
Use Bio-Protect 2 to fight an existing fungal problem or prevent or reduce growth.

PREVENTION

MARITIM CONSULTANTS AS strongly recommends a prevention dose of Bio-Protect 2 each time you fill up.
Following this regime will remove all concerns about a fungal attack.
You can also use COMBAT dosage the first time and then use the PREVENTION dosage after that.

COMBAT

Follow Bio-Protect 2 dosage recommendations and instructions, to remove all problems with fungal infection.

DETECTION

To be certain what level of infection you have, the diesel must be analysed.
Analysis can be taken on site using our DIPSTICK COMBI diesel test, or at our laboratory.
You are welcome to use MARITIM CONSULTANTS own laboratory or consultant service.

Contact us with any questions you might have regarding diesel fungal problems, or about our products.

PRODUCT DESCRIPTION

Bio-Protect 2 is an algae, fungal and bacteria combating biocide, which has shown to be extremely effective in reducing the total micro flora in diesel and diesel/water mix.

Bio-Protect 2 is totally soluble in use and does not damage engine parts.

Contact us with any questions you might have regarding diesel fungal problems, or about our products.

INSTRUCTIONS FOR USE

Bio-Protect 2 can be added directly in the diesel-, day or settling tank, via filling or measuring pipes, manhole or pumped in using a transfer pump.

Bio-Protect 2 should always be added before bunkering when added to the bunker tank.
Be certain that Bio-Protect 2 is well mixed with the diesel in the tank and fuel system.

Bio-Protect 2 requires ca.1 day to completely combat fungal infection in fuel.

After this we recommend a PREVENTION dosage of Bio-Protect 2, to prevent future problems with fungus.

SEE ALSO:
Dosage and Problem solving for Bio-Protect 2.

LOW INFECTION LEVEL:
Cleaning is not necessary before adding Bio-Protect 2.

MODERATE INFECTION LEVEL:
Cleaning is not usually necessary before adding Bio-Protect 2.
Fungus etc... will be destroyed but the waste material in the base of the tank is likely to cause problems in the future.

HIGH INFECTION LEVEL:
Cleaning is necessary before adding Bio-Protect 2.

Contact us with any questions you might have regarding diesel fungal problems, or about our products.

DOSAGE Bio-Protect 2

1:2000 combatting fungal infection
1:5000 prevention of fungal infection.

These are the usual dosage. Very large concentrations of fungal infection can require larger doses.

Always have the product datasheet available when using larger doses of Bio-Protect 2.

Contact us with any questions you might have regarding diesel fungal problems, or about our products.

CONTROL

You are welcome to use MARITIM CONSULTANTS service, use our DIPSTICK COMBI diesel test, or have your diesel tested at our laboratory.


Data Sheet